Radwag PUE C41H Indicator Bedienungsanleitung PDF herunterladen (Seite 120)

Module accessible in three configurations:

• Voltage output AN 0-10V

• Current output AN 4-20mA

• Current output AN 0-20mA

27.2.1. Technical specification

Work modes 4 - 20mA , 0 - 20mA, 0 - 10V

Resolution 16 bit

Current output resistance <500

Voltage output resistance >400

Power supply 24V DC (12 - 30V DC) max 40mA

27.2.2. The way of installing inside PUE C41H

These modules are intended to mount inside PUE C41H. They need to be

connected to the 10-pin J12 connector. For all configurations of AN, there

is a gland installed on the back wall of the housing. A 3-meter shielded

cables are led out via the gland. Wires should be free from insulation.

Installation procedure:

1. Unplug the scale from mains;

2. Unscrew and take off the back wall of the housing;

3. Install your module in J12 on the main board;

4. During installation turn your attention to plastic columns. They

should be placed one side in mounting holes in the main board

and the other side in the mounted module;

5. Led the PT0015 cable through one of the free glands;

6. Connect the PT0015 cable to J3 on the analogue module according

to the description below;

7. Connect the PT0015 cable shield to the housing

(screwed terminator, 4mm diameter);

8. The cable connect to the group of wires (unhook band clips

fastening the group of wires, lay the cable and hook the band clips).

Band clips of multiple usage;

9. Screw down the back wall.

- 120 -

1 2 ... 115 116 117 118 119 120 121 122 123 124 125 ... 162 163

Keine Kommentare

Radwag PUE C41H Indicator Bedienungsanleitung Seite 120